Just pour 1 cup of baking soda and 2 cups of vinegar down the toilet bowl. Let the enzymes and their natural chemical reaction work their magic on the grease, food or built-up toilet paper and break down the clog for you. Leave your baking soda and vinegar mixture overnight and pour hot water down the toilet bowl.
Make your own drain cleaner by pouring one cup of baking soda and two cups of vinegar into the toilet and adding a half gallon of hot water. Dish soap can also help loosen some obstructions. When using either method, allow the solution to sit overnight and then flush the toilet to see if the obstruction has cleared.
Firstly, pour half a cup of baking soda into your toilet bowl and then pour half a cup of white vinegar on top of it. Though this could work on its own, pour between two and three litres of warm water to help with the reaction.
Is it okay to leave a clogged toilet overnight? In most cases, you can leave a clogged toilet overnight. However, calling an emergency plumber near you might be warranted if water starts leaking from the pipes. A simple clog likely won't cause this, but an inexperienced homeowner messing with the plumbing could.
Using a plunger is one of the most effective methods used for unblocking a toilet as it can unclog a wide variety of waste pipes. Anyone unsure how to unblock a toilet at home should first use a plunger: Use the rubber end of the plunger to cover the outlet at the bottom of the bowl.
A combination of hot water, baking soda and vinegar usually manages to unblock clogs caused by too much waste. Boil two litres of water and let it cool down while you pour one cup of baking soda and two cups of vinegar down into the bowl.
Stop Flushing!
The clog will prevent the water from going down the drain, meaning it will overflow the toilet and get all over the floor. This can create a much bigger (and must smellier) mess. You should never flush a clogged toilet more than once.
Pouring hot water in is the simplest way to unblock a toilet, especially if the blockage is only partial. Before you start, make sure that the water level inside the toilet bowl is low. If needed, transfer excess water into a bucket and dispose of it through an external drain.
When a toilet has a clog made of water-soluble materials, it has a chance of slowly dissolving in the water and freeing up the toilet to work properly again. So, clogs that are primarily made of toilet paper can clear themselves.
You might want to see if the clog works itself out in time. If you have another toilet you can use, let the clogged one set overnight. The water pressure that builds up in the bowl might actually cause the toilet to unclog itself. After a day's wait, flush the toilet again.
Pour Hot Water into the Toilet
If you need to heat some in the microwave or the stovetop, you don't want it to reach boiling temperatures. Boiling water can cause toilet porcelain to crack. Allow the hot fluid to sit in the toilet for a few minutes to loosen the clog.
Push down gently at first, since the first plunge will push air into the bowl and could splash back. Then pull up sharply to disturb the clog and loosen it. Continue vigorously pushing and pulling until the water begins to drain. It may take 15 to 20 cycles before the toilet unclogs.
When you are using a baking soda and vinegar solution to clean out your drain, you are actually causing the rubber and plastic that are used for the drain's pipes to be eaten away by the mixture. Over time, this rubber and plastic will break down, causing the drain to become even more blocked.
As it turns out, you can actually unclog a toilet with dish soap instead of turning to a harsh, toxic bowl cleaner. Just as natural dish soap helps break down dirt, grease, and food that may be stuck on dishes and utensils, it can help break down what's in your toilet bowl.
Combined, baking soda and vinegar can sometimes clear a clogged sink, but in many cases, they can also take care of a toilet clog. However, to avoid a small eruption all over the bathroom floor, you'll want to measure them very carefully.
Use a 2-Liter Soda Bottle
Fill a 2-liter soda bottle with hot water from the tub. Place your gloved thumb over the opening of the bottle and then place it into the toilet bowl. Start squeezing the bottle to shoot out the hot water. The hot water, plus the water pressure, should dislodge the clog.
It is safe to leave baking soda (and vinegar) to work overnight to unclog a drain. Always flush this mixture down with boiling water—no matter how long you leave it sitting in the drain.
Use your instincts; if it looks like one cup is going to cause too much fizz, use less or pour more slowly. Allow the fizz to sit for at least 20 minutes. See if it worked. Once the clog is broken up, the water level should go down.
You may be surprised to learn that pouring soda down the drain does work for some clogs. To be specific, you need a dark-colored cola (such as Coca-Cola or Pepsi). This type of carbonated beverage usually contains a good amount of phosphoric acid, which given enough time, can eat away at some types of clogs.
If your clog is going to come out, it should happen in less than 10 minutes. If not, it's time to move on to a snake or call a plumber.
A constantly running toilet also presents an increased risk of flooding. This risk can come in a few forms. When you have a septic tank, excess water can go over the tank's capacity, which can lead to sewer backups and basement flooding.
Most of the time, you'll realize that your toilet is clogged right away. Your toilet is clogged if: You can't flush away waste or toilet paper. The water level is rising higher than it should.
Depending on the water pressure to your house, a running toilet can leak over one gallon of water per hour. This is almost one unit of water a month. If left undiscovered, a running toilet can waste almost 13 units of water a year. Fortunately, most toilet leaks are relatively easy to fix.