What is the minimum distance between toilet and wall in Australia?

Leave at least one meter between the front of the basin and the wall or other items nearest to it. The minimum distance between the rear wall of the toilet and the adjacent wall is usually 1500mm, however, spacing requirements are dependent on the position of the door and toilet.

Takedown request   |   View complete answer on buildsydney.com

How far does a toilet need to be from a wall Australia?

Most plumbers will tell you that the standard rough in distance is between 140 and 165mm for a toilet installation. If yours is more than that, your toilet choices become more limited.

Takedown request   |   View complete answer on goldcoastplumbingexperts.com.au

How much clearance do you need between a wall and a toilet?

Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture.

Takedown request   |   View complete answer on thisoldhouse.com

What is the minimum clearance around a toilet in Australia?

You will need to establish the minimum requirements for space around your bathroom: Allow at least 600mm in front of the toilet and approximately 200mm either side of the bowl for elbowroom.

Takedown request   |   View complete answer on mbawa.com

What is the building code for bathrooms in Australia?

Standard bathroom room sizes

The standard for small bathrooms is 1.5 x 2 metres. Large bathrooms measure up to 3.2 x 3 metres. Bathroom sizes in between, often measuring 2.8m x 2.3 metres, are also adequate for households nowadays.

Takedown request   |   View complete answer on dream.space

Distance From the Toilet to the Wall Framing : Toilet Repairs

38 related questions found

Do I need building regulations for a toilet?

Building Regulations

As a downstairs toilet will involve plumbing, electrical, and heating, you'll need a building control completion certificate which proves the work done complies with safety standards. The professionals you hire to do the plumbing, heating, and electrical will be able to help you sort this.

Takedown request   |   View complete answer on abacusflame.co.uk

Do I need permission to install a new bathroom?

The short answer is, to start the process of upgrading your bathroom, you usually need permits. When you make changes to plumbing, electrical, or structural components of your home, you need a permit from the Department of Buildings.

Takedown request   |   View complete answer on sweeten.com

What is the minimum distance between shower and toilet?

Leave at least 15" of space between the shower and toilet or other obstacle. If you have a swinging door, take into consideration nearby fixtures. To prevent a collision, consider the placement of hardware including towel bars, handlebars, and light fixtures.

Takedown request   |   View complete answer on wayfair.com

What is the minimum area for a toilet and bathroom?

Common Bathroom size layouts

In general, the smallest size is 15 square feet, which can fit a sink and a toilet. For a shower, to be installed, at least 30-36 square feet is required. For a full bath consisting of both a shower and a bathtub, you will need at least 40 square feet.

Takedown request   |   View complete answer on badeloftusa.com

Can you have a toilet next to a kitchen Australia?

Re: bathroom near kitchen

The additional requirements are that there must be one door, the bathroom must have a sink within it, and you must meet all other requirements for plumbing, including fixture spacing, ventilation and drainage. You'll need to verify with the Building Code of Australia.

Takedown request   |   View complete answer on workshop.bunnings.com.au

What is the smallest space for a toilet?

The minimum size for a downstairs toilet is 70cm wide x 130cm long. However, to make it a functional and comfortable space, you ideally want to be working with a footprint of 80cm x 140cm; in either instance the door would typically have to open outward.

Takedown request   |   View complete answer on more-bathrooms.co.uk

Does a toilet need to be against a wall?

No, a toilet does not necessarily need to be placed against a wall. It can be positioned away from the wall as long as it is properly connected to the plumbing system for waste disposal and water supply.

Takedown request   |   View complete answer on quora.com

What is the rough in distance for a toilet?

What is a rough-in size for a toilet? A toilet's rough-in size measures the distance from the back wall to the center of the drainpipe, otherwise called the toilet flange. This rough-in measurement usually comes in at 12 inches, but some bathrooms and toilets require 10-inch or 14-inch rough-in distances.

Takedown request   |   View complete answer on angi.com

Are toilets a standard distance from the wall?

#2: The Clearance From the Center of the Toilet To Any Adjacent Fixture or Sidewall. This measurement is 15 inches. That's the minimum (you can have more). So looking at the toilet, make sure there are at least 15 inches of clearance from the center of the toilet to any adjacent fixture (or wall).

Takedown request   |   View complete answer on hammerpedia.com

What is the minimum distance that a water closet toilet from the the side wall is allowed measured from the centerline of the water closet?

The centerline of the water closet shall be 12 inches (305 mm) minimum and 18 inches (455 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum from the side wall or partition in the ambulatory accessible toilet compartment specified ...

Takedown request   |   View complete answer on ada-compliance.com

Do you need a plumber to install a toilet Australia?

Keep in mind when installing a new toilet in a completely new location you will need a plumber to connect the sewer drain and water supply line run as this must be done by licences plumbers.

Takedown request   |   View complete answer on goldcoastplumbingexperts.com.au

How much space do I need for a toilet room?

The size for a separate toilet compartment should be at least 36x66 inches with a swing-out or pocket door. Code Requirement: The minimum size for a separate toilet compartment is 30x60 inches.

Takedown request   |   View complete answer on bhg.com

How much width do you need to allow for a toilet?

In an open bathroom, allow a width of at least 750mm (although 900mm is preferred!) for the toilet to reside in to give the user enough space to sit comfortably without their elbows touching the walls. A length of between 1200 and 1500mm is usually sufficient.

Takedown request   |   View complete answer on caroma.com.au

Can you put a toilet where a shower was?

Toilets need to be supplied with water, so placing yours where the shower was means that's easy to do. Grab some PEX pipe and connect it to the cold water supply, and pipe it to where the toilet will now be placed. The pipes will run between the wall, and finish it off with a turn valve.

Takedown request   |   View complete answer on victoriaplum.com

How narrow can a toilet room be Australia?

In Australia, baths, showers and cabinetry tends to run to a "standard" size, so it's worth considering the below and keeping it in mind while you design. Allow a width of at least 750mm for the toilet to reside in, and a length of between 1200 and 1500mm.

Takedown request   |   View complete answer on bhg.com.au

What is the minimum shower width in Australia?

Minimum Shower Size Australia

In general, a shower could measure at least 90cm x 90cm. However, if your bath space is especially petite, 75cm is the absolute minimum space requirement for a shower area.

Takedown request   |   View complete answer on buildsydney.com

What is the ceiling height above a toilet?

The minimum ceiling height for bathrooms and toilet rooms is 6 feet, 8 inches (2032mm). There are exceptions, including a sloping ceiling over the toilet if the minimum ceiling height of 6 feet, 8 inches (2032mm) is maintained over the front clearance area.

Takedown request   |   View complete answer on nachi.org

Can you put a toilet anywhere in your house?

Who says that your toilet can't go in the closets where the coats should be? It's your house, and it's your right to know where you can and can't place a toilet! On a serious note, it is absolutely possible to install a toilet, even a bathroom as a matter of fact, anywhere in your house.

Takedown request   |   View complete answer on tandemcontracting.com

Can a plumber install a bathroom?

Plumber: Most plumbers will be familiar with the majority of bathroom installation jobs. If you are having a wet underfloor heating system they will also be able to help with this.

Takedown request   |   View complete answer on homebuilding.co.uk

Can you build a new bathroom anywhere in your house?

As long as you have a little available space, access to sufficient electrical outlets, ventilation and adequate sound insulation, you can sneak a new bathroom almost anywhere in your home. It may feel like you don't have any available space to spare, but there's a good chance you just don't know where to look.

Takedown request   |   View complete answer on homeclimates.com