If water is rising in the bowl immediately after you've already flushed, that means a clog is blocking the water from moving through the toilet drain. If you flush again, there will be even more water that's unable to make it past the clog, and you'll end up with even more flooding from the toilet bowl.
If your toilet is backing up, it may be due to your tank not having enough water to flush it. Low tank water levels may result from several causes. Damaged water supply lines, broken tank seals, and other issues may prevent tanks from filling completely. Some toilet models may also have low flush strength.
If your water is rising to a higher level in the bowl itself, it means there is something blocking the drain. A clog can be caused by excessive toilet paper, foreign objects that have been dropped in the bowl or sediment buildup in the pipes.
A clog in the toilet, toilet flange, or drain
If you have a clog anywhere in the system, this will prevent water from fully flushing down the toilet. Depending on where the clog is and how severe it is, you'll either be able to remove it on your own or you'll need help from a professional.
We believe it's our duty to give you the ins and outs of what to do when you face a toilet clog. While it's true that sometimes all a clog needs to get moving is an extra flush, a person who flushes a clogged toilet runs the risk of the toilet overflowing. Wait until the clog is loose to attempt flushing.
You can use Drano® Clog Removers to unclog a kitchen sink, bathroom sink, shower or clogged bathtub, but DO NOT use them in toilets. For clogged or slow-running drains, apply the product and let it work 15 minutes, then flush with hot water. For tough problems, allow 30 minutes before flushing.
Caustic Soda
Caustic soda is a nasty chemical that can burn, but it's very effective for unclogging toilets. To use this chemical, you need to get some rubber gloves and eye protection. You can pick up the chemical from the local hardware or grocery stores.
This is what you want to do: combine two cups hot water with two cups white vinegar. Pour one cup of baking soda into the clogged toilet, and then chase it with the hot water/vinegar mixture. Leave the volcano mix to do its job, checking in about 30 minutes.
Simply pour about half a cup of dish soap into your toilet bowl, followed by one cup of vinegar, then let it sit for about 30 minutes before flushing. Using dish soap and vinegar to unclog your toilet is not only cost-effective but also eco-friendly.
Will a toilet eventually unclog itself? It sure would be nice, but it's fairly rare for a toilet's clog to clear up after a few hours. It can happen, but only in select circumstances.
Push down gently at first, since the first plunge will push air into the bowl and could splash back. Then pull up sharply to disturb the clog and loosen it. Continue vigorously pushing and pulling until the water begins to drain. It may take 15 to 20 cycles before the toilet unclogs.
Mix baking soda and vinegar in the ratio of 1:2 and add the mixture in 60 gallons of water. Use the plunger or drain snake as you pour the water into the drain. If you are wondering how to unclog main sewer line, the pressure of the water will dislodge the debris easily.
First, you can run hot water down the drain for 5 to 10 minutes to see if that helps break up the clog. If it doesn't, pour equal parts of vinegar and baking soda into a bowl and then pour that mixture down the drain. Let it sit for 15 minutes, and then run hot water down the drain.
In most cases, you can leave a clogged toilet overnight. However, calling an emergency plumber near you might be warranted if water starts leaking from the pipes. A simple clog likely won't cause this, but an inexperienced homeowner messing with the plumbing could.
When it comes to simpler clogs, expect to pay no more than $150, while more extensive blockages that require dismantling the toilet's plumbing could cost between $150 and $500. A DIY drain snake costs between $5 and $50, so it may be affordable for homeowners to take the first attempt at unclogging themselves.
Hot Water and Dish Soap
Wait for 10-15 minutes while the dish soap and hot water soften the clog. Once you do so, the toilet will unclog and flush freely. Alternatively, you could use hot water and shampoo from the sink if you wish to clear your toilet without leaving your bathroom.
Coke or Pepsi are great for vanquishing a clog! Everyone's heard about how a nail will dissolve in a glass of coke over time, and although most of us know this is a stretch, coke is arguably better than many commercial chemical clog removers because of its strong dissolving agents!
As it turns out, you can actually unclog a toilet with dish soap instead of turning to a harsh, toxic bowl cleaner. Just as natural dish soap helps break down dirt, grease, and food that may be stuck on dishes and utensils, it can help break down what's in your toilet bowl.
When you notice a nasty clog or your toilet won't flush, your best bet is to pour in some hot water. You can turn the tap in your bathroom sink or tub to the hottest setting or heat the water up a bit on the stove, but don't let the water get to boiling point.
If the clog still seems to be intact, start over at step 1 and repeat the process a couple of times. For extra-stubborn clogs, you can let the fizz mixture sit overnight or combine this method with plunging.