Usually petrol/kerosene are the best cleaning products. I use to use unleaded to clean my vespa air filter. Kerosene is a solvent, and can be used to treat haed lice, so I think your carbs should be safe.
I just soak mine in gas or kerosene. A toothbrush does the trick after that.
WD-40 allows you to clean your generator carburettor within a few minutes without spending additional time and effort. The potent liquid uses a solvent formula for breaking away carbon contaminants within the carburettor, providing you with a clean and healthy machine in no time.
However, it's important to use a non-corrosive cleaner which doesn't harm or degrade any plastic or rubber pieces on the carburetor. You should avoid using vinegar, because the acetic acid makes metal susceptible to rust.
Adding a fuel stabilizer to the gas tank such as our Total Fuel Stabilizer (parts #0408 or #0416) and topping it off with fresh fuel will accomplish this. Best of luck with the bike!
Yes, Sunnyside Mineral Spirits will work well for this purpose.
Kerosene is a versatile fuel oil that has many uses including fuel for oil lamps and engines. It can also be used for heating and cooking, and as a cleaning agent.
Abstract. Solvents such as kerosene or gasoline may be used by workers to clean their skin following contact with oily materials. This practice is not recommended, as it is well known that the solvent will defat the skin.
Spray the Low Odour kerosene onto the engine and leave the solution for a few minutes. Ensure that it's covered the engine's entire surface. Then, using an old brush, scrub away any grease or grime. Once you've given your engine parts a thorough clean, wash off the kerosene with hot water.
We've tried spraying carb cleaner and a vinegar soak, both with mixed results. A solution of pure lime juice or lemon juice turns out to work the best. Not only does it remove any remaining toilet cleaner residue, but it also leaves your jets smelling great. After the soak, dry the parts using compressed air.
Use carburetor cleaner to remove deposits, clogs & debris
Luckily, you can take care of many of these problems quickly and easily; often without even removing the carburetor from the engine.
With the cleaning mixture in the fuel tank, crank/prime/rope-pull the engine to draw the cleaning mix into the carburetor(s). 6. Allow engine to sit and soak – Overnight to 24 hours if possible, 48 to 72 hours when necessary.
Carburetor cleaner is usually sold as a spray-on aerosol containing the following ingredients: acetone, methanol, ethyl benzene, toluene, and carbon dioxide—all of which help break down the varnish deposits that accumulate within the carburetor.
WD-40 Specialist® Carb/Throttle Body & Parts Cleaner with attachable precision straw is the only all-in-one carburetor cleaner spray you will need to clean your carburetor, throttle body, and unpainted metal parts.
Acetone use in carburetor cleaners is another product exemplifying how 12 percent of all acetone used becomes a cleaning solvent. Highly combustible, safe acetone use requires avoiding any ignition source. High in vapor pressure, acetone contributes to the need for using carburetor cleaners in well-ventilated areas.
Can You Clean a Carburetor With Alcohol? While alcohol may help with other cleanings, it's not good for cleaning your carburetor. Compared to carburetor cleaners, alcohol is much weaker.