Make a baking soda paste with water and spread over tile and grout. Leave on overnight and spray with vinegar in the morning. Follow with your regular morning shower and rinse off any baking soda/vinegar residue. No scrubbing needed!
Cleaning Grout with Baking Soda
Mix baking soda, a few drops of dish soap, and enough water to make a cleaning paste. Apply the paste liberally, let it sit for 20 minutes, then scrub the grout with a toothbrush and rinse.
Baking soda is mildly abrasive so it helps to remove the dirt that is stuck in the porous grout surfaces without causing any damage.
Baking soda is efficient enough to clean the bathroom tiles on its own. Its ingredients are powerful enough to eradicate dirt and stains on the tiles. Apply baking soda on the tiles and leave it alone for a few minutes. After that, all you need to do is clean the tiles.
Let the product sit for 30 minutes. Then, go back in and scrub gently with water. (Our Test Kitchen loves the Scrub Mommy scrubber for all kinds of cleanup tasks.) You'll watch the dirt melt right off the tile and grout.
Baking soda, which is a bit abrasive in nature, can effectively loosen up the dirt particles without causing any damage to the tile surface or the indoor air quality.
Time. Make a baking soda paste with water and spread over tile and grout. Leave on overnight and spray with vinegar in the morning. Follow with your regular morning shower and rinse off any baking soda/vinegar residue.
What do professionals use to clean grout? Whether you believe it or not, most professionals use a solution of white vinegar and water with a 1:1 ratio. This solution is often more effective than dedicated Ph-neutral grout cleaners.
TL;DR: Combine baking soda & white vinegar to create the perfect cleaning solution for tile grout. Scrub with a toothbrush and voila! For floor tiles, combine baking soda and hydrogen peroxide, apply paste, let sit, then scrub away and rinse off with warm water.
If for some reason the grout haze does not come clean or you waited just a little too long, you can use a solution of ½ cup of vinegar, ½ cup of ammonia, 1 cup baking soda and 2 quarts of water or pick up a commercial haze cleaner at the store.
One way to clean grout without scrubbing is by mixing hydrogen peroxide and baking soda. Add 1/2 cup of baking soda to 1/4 cup hydrogen peroxide and mix into a paste. Follow with a teaspoon of dish soap. Apply the mixture to your floor grout and let it sit for 5–10 minutes.
Sponging the grout too soon will pull it out of the joints, so let it set for about 15 minutes. After that, use a damp sponge to clean the face of the tiles in a light, circular motion. Next, clean the sponge and go over the tile again, wiping at a slight diagonal to the joint.
Let the grout set for 15 to 30 minutes, and wipe up the excess grout with a dense grout sponge soaked in water. (If you think it's going to take you longer than 30 minutes to grout all of the tiles and be ready to move onto cleanup, you may have to work in smaller sections.)
Optimally, no more than 30 minutes should pass for the initial wiping off of excess grout. This process must be performed gently with a wet grout sponge during regrouting.
Mix together ½ cup baking soda, ¼ cup hydrogen peroxide, 1 tsp dish soap. Spoon cleaning agents onto grout and let sit for 5-10 minutes. Scrub the grout lines with a brush. Grout cleaning tip: Make sure to scrub hard to agitate the grout and cleaning solution and break up any really stuck dirt.
To remove everyday dirt and debris, mix two parts baking soda with one part water. For stained or discolored grout, mix two parts baking soda with one part vinegar. And if you have coarse or fragile tiles, mix two parts baking soda with one part hydrogen peroxide.
Rinse the sponge you are using in a bucket of water and change as needed as you clean off any excess. Then leave the grout to dry overnight.
You should not wait for more than three hours after the grout has set to remove the haze. If you remove the grout haze within three hours of setting, you can do so with the help of a clean damp sponge.
Although mixing vinegar and baking soda is not considered dangerous, you should still avoid mixing these in a container. Vinegar is acidic and basic soda is basic, so the by-products are sodium acetate, carbon dioxide, and water that are not toxic.
In a bowl, combine two parts baking soda to one part hydrogen peroxide. Mix the ingredients together to form a paste that can be easily applied to the grout. Apply the paste to the grout with a brush. Again, you can apply your cleaning paste with the same brush you'll use to scrub the grout later.
If you have a large surface area - like in a kitchen or a large bathroom - you might want to invest in one of the best steam cleaners to make your job easier. But you can use baking soda or vinegar diluted in a spray bottle to tackle floor tile grub and stains by hand.
Baking Soda, Vinegar, and Essential Oil Cleaning Method
Vinegar is safe to use on porcelain as long as you don't leave it on too long. This method can help clean yellowed porcelain.