The easiest way to do this is to place the level on the tongue of the trailer. This will let you know if one side is higher than the other, which will inform which side you want to raise. Now that you know which side is too low, put boards or leveling blocks behind the wheels you need to raise.
Leveling your RV is not a recommendation but a requirement. It not only increases your comfort during your stay but can help you prevent disaster. Proper leveling will increase the lifespan of your RV and protect against additional repair costs. Below are a few major reasons to ensure your RV is leveled properly.
Simply back (or drive forward) onto the ramps, and when its level, stop. What is this? Apply your hand brake, chock the wheels and disconnect the trailer. From there, level the trailer up and down in the other direction using the jockey wheel, and you should end up with a perfectly level trailer.
Spread the soil until it's roughly even with your level-grade line. Use a shovel, landscaping rake, or flat spade to gradually redistribute the soil from higher areas to lower areas until your entire site has a uniform appearance. As you work, keep an eye on your string lines for reference.
If a trailer is nose up too much, the tongue weight is low enough that the trailer may begin to sway. So in short, level is best. If level is not possible, then try to go slightly nose down. Slightly nose up can be fine, but keep an eye out for trailer sway.
Too much tongue weight could overload the rear tires of the towing vehicle, pushing the rear end of the vehicle around. When this happens, the vehicle is difficult to control; corners or curves may become more difficult to maneuver and your vehicle may not be as responsive when you try to brake.
For travel trailers, or any type of trailer, you'll place both levels outside. One will go on the passenger side of the front of the trailer left to right, while the other will go on the driver's side front to back.
Whenever a vehicle towing a trailer travels along the road with the back down and front up, a problem of weight transfer exists. This means that there is less weight on the front wheels but more on the rear. For maximum safety, stability and vehicle control, both the caravan and towing vehicle should be level.
Before Extending an RV Slideout
Before you extend an RV slide-out, your unit must be parked, properly leveled, and stabilized. Stabilizing jacks must be in place under your chassis before extending slides.
An RV needs to be level because storing an unlevel RV can cause stress on the frame and the slide-outs. It can also cause a fire in an RV fridge and make your tank fluid readings inaccurate. Not to mention, it's easier to prepare an RV for storage when it's level.
If your RV isn't level, your slides can malfunction. Similarly, if your slides sit extended on an unlevel surface for more than a couple of hours, they can suffer damage. The weight and stress points aren't in suitable locations when the RV is unlevel.
Expert Reply: Your leveling system is not supposed to lift the wheels off the ground; this could exceed the capacity of your leveling system and cause damage and I do not recommend doing so.
Balancing also contributes to overall ride comfort. Imbalanced tires can wobble or hop up and down, causing vibration. If a front tire isn't properly balanced, you'll likely feel vibration in the steering wheel. If the problem is in the rear, you'll feel shaking in the seat or floor.
The best way to stop your travel trailer from rocking is by using a combination of leveling jacks which reduce up and down motion, stabilizers that reduce side to side motion, and wheel chocks to reduce any movement of the tires.
Your goal is for the hitch and vehicle's receiver to be riding high enough from the ground to avoid scraping, even on potholes and bumpers. In order to achieve this, a trailer hitch should be at least 17 inches off the ground. If you put weight on the travel trailer, it will lean on the front area.
If your hitch is too high, more weight will be shifted to the trailer's axle(s). If your hitch is too low, more weight will be shifted to the towing vehicle. Either way, your towing experience will be adversely affected, causing any one of a number of potentially serious issues.
If your tongue weight is too low, move the load forward a bit. If you need to reduce tongue weight, move the weight further back on the trailer.
What is a Leveling Rake? As the name suggests, a lawn leveling rake is a gardening tool used for smoothing uneven surfaces in your garden. It serves several functions and fills out the holes and cavities present in the ground surface by shuffling the material.
An uneven surface or edge is not smooth, flat, or straight.