Do: Dish Detergent and Warm Water. Although it may seem simple, the best homemade cleaner for diamond jewelry is a solution of dawn dish detergent and warm water. This solution is perfect for normal use which is expected for newer jewelry.
"The best way to clean diamond rings is to make a solution with warm water (almost hot) and dishwashing soap. Soak your ring for about 20 to 40 minutes, gently brush the stone with a very soft toothbrush, and then rinse under warm running water," advises Mann. "If needed, repeat."
The best mixture of cleaning solution for diamonds is ammonia or mild dish detergent with water. The ratio of this solution should be a quarter cup of ammonia to one cup of lukewarm water. After mixing the solution, simply let the piece of diamond jewelry soak in the solution for 20-30 minutes.
Vinegar & Baking Soda
Start by pouring 1/2 cup white vinegar and 2 tablespoons baking soda into a shallow bowl. Mix the solution until the baking soda is completely dissolved. Then, soak your diamond ring in the solution for two to three hours. Rinse your ring under cold water and dry thoroughly with a soft cloth.
A simple plan to keep your diamond jewelry looking beautiful is to soak it in a gentle degreasing solution, such as water with a few drops of mild dish soap, once or twice a week. After you remove the diamond from the cleaning solution, use a soft, clean toothbrush to remove any remaining dirt.
To clean diamonds, professional jewellers will use a specialised device referred to as an Ultrasonic Jewellery Cleansing Bath to get your piece sparkling once again. This device uses vibration and ultrasonic sound waves to lift the dirt and other pollutants off your diamond.
Use Ammonia
Work is required to keep your diamond shining bright. Diamond jewellery can be cleaned by soaking it in a solution of one cup of warm water and one-fourth cup of ammonia for about 15 minutes.
Jewelers use ultrasonic cleaners with high frequency sound waves and chemicals, which create bubbles that latch on to the dirt on the diamond. The high frequency sound waves pull the dirt away from the stone and bring them up to the surface.
You can soak your engagement ring for five minutes in witch hazel or white vinegar for a deeper clean. Before scrubbing with soap or a vinegar solution, be sure to rinse your ring in warm running water. You can then dry your rings with a soft cotton cloth or let them air dry in a safe place.
While vinegar is slightly acidic and needs to be used with caution on more porous stones, it will do a fabulous job on your diamond ring. Simply mix a half cup of white vinegar with 2 tablespoons of baking soda. Stir until the baking soda is totally dissolved, then soak your diamond ring in the solution for 2–3 hours.
Toothpaste, baking soda, bleach, and other household cleaners are abrasive. While they won't damage your diamond, they can damage your gold. Windex won't hurt your ring, but it isn't a great cleaner either. So stick to mild soap and water, and six-month cleanings and check-ups at your jeweler.
Add approx. 10 drops of Dawn Dish Soap to a small glass or jar, then fill with warm {not hot} water. Remove your ring, and gently place it in the jar, and allow to soak for 15 minutes.
Fill one bowl with hot water and add dish soap. Fill the other bowl with cool water to rinse. Mix the soapy warm water with the toothbrush and gently scrub the ring, paying close attention to crevices where dirt can collect. Let the ring soak in the warm water for about 15-30 minutes.
The best way to clean a diamond at home is to put it into a bath of warm water and a few drops of dish soap. Let it soak for 20-40 minutes and wipe it dry with a lint-free cloth. If stubborn stuck-on dirt remains, repeat the process but scrub the ring gently with a soft-bristled toothbrush this time.
A diamond that has not been cleaned for a while can look milky due to a buildup of film and dirt on its facets. Cloudy diamonds can also have diminished transparency from inclusions or other characteristics intrinsic to the crystal from which they are cut.
A dirty stone doesn't sparkle because light simply can't enter the diamond and causes it to appear dull. So, if you notice your diamond jewelry getting cloudier overtime, it's likely due to a dirty surface and there's an easy fix to restore their luster.
Diamonds gain their characteristic sparkle by using lasers to scrape away their dull, rough outer surface and create and polish angled facets that allow them to sparkle.
The best way to clean your diamond jewelry and restore its sparkle is to: Spray a soft-bristled toothbrush with Windex and gently brush diamond jewelry thoroughly, removing any dirt on the surface of the diamond or dirt that has settled in and around the metal.
When light enters an ideally-cut diamond, the light bounces around its internal facets, bends, and exits through the top of the diamond. This is known as refraction. Refraction creates a sparkle in a diamond as a result of light bouncing around the inside, which hits your eye when the stone is in motion.
There are many common cleaning products that people may think are good to clean diamond rings with, but they can actually be quite damaging. Chlorine bleach, abrasives (like toothpaste or baking soda), or acetone should never be used on any jewellery.
Mix 1 teaspoon dishwashing liquid and 1 cup warm water. Add 1/2 teaspoon of ammonia based household cleaner (like a glass cleaner such as Windex) Soak your jewelry in the solution for about 5 minutes & then gently scrub with a soft-toothbrush. Air dry or carefully towel-dry with paper towel or regular cloth.