Dish soap is preferred, but if you can't break free to the kitchen, liquid hand soap, body wash, or a bath bomb can work. Squeeze about a quarter cup (or as much as you can) as close to the hole as possible. Add some hot (not boiling) water and let sit to help lubricate and loosen the clog.
Caustic Soda
Caustic soda is a nasty chemical that can burn, but it's very effective for unclogging toilets. To use this chemical, you need to get some rubber gloves and eye protection. You can pick the chemical from the local hardware or grocery stores.
Make your own drain cleaner by pouring one cup of baking soda and two cups of vinegar into the toilet and adding a half gallon of hot water. Dish soap can also help loosen some obstructions. When using either method, allow the solution to sit overnight and then flush the toilet to see if the obstruction has cleared.
Pour Hot Water into the Toilet
Boiling water can cause toilet porcelain to crack. Allow the hot fluid to sit in the toilet for a few minutes to loosen the clog. If you see it start draining, you'll know that you've been successful!
The Passive Solution
Let water dissolve the clog, and try flushing again after several hours. By pouring a caustic soda (coke, for example) into the toilet bowl, you can speed the dissolving process along considerably. Simply dump a can of cola in the water and let it eat away at the debris.
A partially clogged toilet can sometimes be cleared just by using hot water. The pressure produced by the hot water helps to push material blockages away, while the heat works to dissolve any fat or grease that may also have built up.
Baking soda and vinegar – put one cup of baking soda into the blocked toilet and wait two minutes. Afterwards, slowly pour two cups of vinegar and wait a few minutes before flushing the toilet. Dish soap and water – put dish soap, then hot water into the toilet.
One and only one Drano product
There is only one Drano® product recommended for use in slow-running toilets: Drano® Max Build-Up Remover. It contains microorganisms that break down organic matter in pipes that can slow water flow. (However, it will not open a completely clogged toilet.
Ideally, no more than five or 10 minutes. One plumber told us that if plunging goes on any longer, it's time to try a toilet snake or call an expert.
For extra-stubborn clogs, you can let the fizz mixture sit overnight or combine this method with plunging. If your toilet remains clogged or continues to get clogged, this may be an indication of plumbing problems such as mineral buildup or pressure issues.
Is it okay to leave a clogged toilet overnight? In most cases, you can leave a clogged toilet overnight. However, calling an emergency plumber near you might be warranted if water starts leaking from the pipes. A simple clog likely won't cause this, but an inexperienced homeowner messing with the plumbing could.
Pour one cup of baking soda into the clogged toilet, and then chase it with the hot water/vinegar mixture. Leave the volcano mix to do its job, checking in about 30 minutes. In most cases the clog will have come apart, and a simple flush with send it all down the drain.
Your toilet may keep clogging due to blocked plumbing vents. Blocked plumbing vents will cause water to drain slow. Slow draining water will cause your toilets to keep clogging. A plumber can check your vent pipes and unblock them.
Push down gently at first, since the first plunge will push air into the bowl and could splash back. Then pull up sharply to disturb the clog and loosen it. Continue vigorously pushing and pulling until the water begins to drain. It may take 15 to 20 cycles before the toilet unclogs.
First, shut off the water supply to the toilet. To do so, find the valve mounted on the wall behind the toilet. Turn it until the water flow stops. If you can't find the water shut-off valve, lift the top of the tank and lift the float ball high enough to stop the flow.
While the baking soda and vinegar solution is effective in breaking down a clog, it will also cause your drain to become more damaged. The baking soda's abrasive nature will wear down your drain over time. This is why you should avoid using baking soda and vinegar solution for cleaning out your drain.
Cola Drain Cleaner Trick
Pour the entire bottle down the clogged drain. Allow it to sit in the drain for at least an hour or two (or even up to 24 hours for stubborn clogs). Flush drain with boiling water. Repeat as necessary.
How to Unclog Your Toilet With Baking Soda & Vinegar. If the clog is minor, pour all of the baking soda measured into the toilet bowl. If the clog is severe, pour up to one-half a cup of baking soda in the toilet. Remember to use equal parts of vinegar and baking soda.
You can use straight or a diluted vinegar cleaning solution for the bathroom to clean bacteria, especially around the toilet. Cleaning with a mixture of baking soda and vinegar in the bathroom can work really well. To clean your toilet with vinegar, pour a cup of vinegar in the toilet bowl and let sit overnight.
Let the mix sit for anywhere between two hours to overnight. If the water levels have drained try flushing, and if the water levels have not moved you can try plunging gently plunging. For tougher clogs, you can try cycling baking soda, hot water, and vinegar; flush and plunge as needed.
Because of its corrosive nature, Drano can cause toilet bowls to crack, PVC pipes to melt or break and the glue that holds pipes together can be eaten away. If any of these things happen, you're going to be left with an inoperable plumbing system and costly repairs.