The U-shape was meant to give ladies plenty of room to wipe without having to stand up or touch the seat directly. That's especially helpful for those of us nesters who like to put down a layer of toilet paper on the seat before we pop a squat. Don't like that answer? Think there's more to it?
While not every country is governed by these rules, many site toilets still adopt this seat style for hygiene reasons. Split toilet seats offer more space so the user won't accidentally hit the seat with their genitals, and it also reduces the chance of splashing urine onto the front of the seat.
The gap that exists at the front is designed for hygiene purposes to prevent people from touching the seat with their genitals. It also gives women an easier access point to clean up after themselves without brushing their hand against the seat.
Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.) There should be at least 24 inches of clear space in front of a toilet or bidet.
- Lids cost a lot to replace, and they need to be replaced a lot! Believe it or not, people steal them! - And when the lids aren't stolen, they break! Hinges are a weak spot on any toilet seat and, if the bathroom is busy, hinges get a lot of use—some of it rough.
Easier to Clean: By having a gap at the bottom, bathroom partitions are much easier to clean, as is the whole restroom. You can hose down or even powerwash a restroom that has partitions with gaps at the bottom because the water has somewhere to run even if there's not a drain in a given stall.
It's more hygienic. The most obvious reason to leave the toilet lid down is because it's more hygienic. Toilet water contains microbes of… well, everything that goes down it, to put it politely. Many bugs and infections have also been found in toilets, including the common cold, flu, E.
You need to allow at least a 750mm wide space for your toilet, and between 1200mm-1500mm of length. The bathroom vanity standard size varies depending on type. The most common bathroom vanity is the single, which is usually 500cm – 1.2m. Standard double vanities are between 150cm and 180cm wide.
The minimum size for a downstairs toilet is 70cm wide x 130cm long. However, to make it a functional and comfortable space, you ideally want to be working with a footprint of 80cm x 140cm; in either instance the door would typically have to open outward.
In an open bathroom, allow a width of at least 750mm (although 900mm is preferred!) for the toilet to reside in to give the user enough space to sit comfortably without their elbows touching the walls. A length of between 1200 and 1500mm is usually sufficient.
The main purpose of a dual flush button is to save water. The dual flush button allows the user to control the waste water. The smaller button (half flush) delivers a smaller volume of water than the larger button (full flush). What is a single flush button?
The main reason toilets are not incorporated into the bathroom, however, is that the Japanese bathroom, which normally comprises an enclosed bathing area and a senmenjo — a chamber with a sink, a changing area and sometimes laundry facilities — is not very private.
For the first time, the fact that women simply take longer on the toilet—partly because they have to enter a stall and sit down, but also because they have periods—was publicly addressed. The law passed, and it stipulated that new buildings have at least 50 percent more bathroom stalls for women than for men.
You'll often notice gaps between the sides of the stall doors as well – This is in place to discourage inappropriate behavior within the bathroom stalls. It's also easier for law enforcement to locate criminals if they are on the run and have chosen a public restroom as their hiding place.
Jet hole: An opening near the bottom of some toilet bowls to increase the pressure of the flush and help decrease the chance of clogging.
That little space allows you to determine which stalls are open without bothering anyone because you can glance down and look for feet. Additionally, it's much easier to run a mop or broom through a bathroom with bathroom stall doors at the height they are.
In the past people have thought that a bathroom or toilet couldn't open out into a kitchen, but this isn't the case. As long as there is a basin where people can wash their hands before returning to the kitchen, then one door is enough. And you don't need a lobby.
This room in people's houses can also be called the lavatory, or informally, the loo. An extra downstairs toilet in a house can be called the cloakroom.
But adding a downstairs toilet isn't as simple as it might first appear, and there are many rules and regulations to consider. Planning permission is generally not required to add a bathroom into a property, assuming it is not forming part of an extension to the building.
Standard toilets measure approximately 650mm x 380mm x 816mm (depth x width x height). Make room for this, plus a few more millimetres of unobstructed space in front and on both sides of the toilet for ease of movement. Leave at least 700mm of space in front and 200mm on either side of the toilet.
Most new homes have a standard set-out of about 140-165mm, which is suited to most toilet suites. However, if the set-out is more than 200mm or less than 100mm, your choices are limited. So make sure you you take your set-out measurements with you when you go toilet shopping.
Standard Bathroom Size Australia
The minimum bathroom size building regulations Australia measures 140cm x 95cm in a rectangular floor plan and 120cm x 120cm on a square floor plan. This only includes a toilet and a basin, and it has different allowances per state.
Conventionally, it's considered courteous for men to always lower the seat back down after they've urinated.
The lid was designed to keep germs where they belong, in the bowl and down the drain! If you leave the lid up when you flush, those germs can float around your bathroom, landing on any available surface, including towels, hairbrushes or even toothbrushes.
This is probably largely because many Japanese prefer not to sit directly on toilets outside of the home, which they suspect may not be very clean.