The carbonic acid that is in coke is what helps to clean toilet stains. Picture the acidity slowly working its way through the stains, melting them away. It can take a while depending on how stubborn the stain is which is why it's vital to have a suitable cleaning method depending on how bad the toilet condition is.
Things You Should Know
Let the Coke sit for at least 2 hours, or overnight. Then, flush the toilet to rinse away the stains. If you're dealing with tough stains, scrub them with a toilet brush and heat the Coke in the microwave for 30-60 seconds before pouring it in the toilet bowl.
Pour a half-cup of hydrogen peroxide into the toilet and let it sit for 30 minutes. Use your toilet brush to scrub the stains. Add a sprinkle of baking soda and scrub again if the stains persist. Turn on the water and flush away stains and germs.
Coca-Cola Cleanser
It may sound like an urban legend, but plenty of folks swear that Coke dissolves toilet rust rings. Here's how: Pour a full can around the rim so that it fully coats the bowl, then let it sit for at least an hour to allow the soda to break down the stains. Scrub with a toilet brush, then flush.
Also, make a simple routine part of your weekly cleaning: Sprinkle the toilet with cup of baking soda. Let it sit for 30 minutes, then spray or squirt with vinegar (a mild acid) to moisten. Scrub with a bowl brush and flush away [source: Niagara County].
White vinegar is the must-have cleaning essential for your home, so of course you can use it in the bathroom too. Just pour some into your toilet bowl and let it sit for a few minutes, even better if you can leave it overnight, before scrubbing it away. This is sure to make your loo look as good as new.
While it can be put to a number of helpful uses around the home, WD 40 is particularly good at softening rust and limescale deposits in the toilet (and bathroom). All you have to do is spray it on the desired section of the toilet, wait a few minutes, then scrub it away with a toilet brush.
Or perhaps you are seeing some black stains in your toilet bowl or dishwasher? These unsightly stains may be a result of high levels of manganese in your water. Manganese is a natural element that is commonly found in water, soil, and some foods and, at appropriate levels, plays a role in keeping us healthy.
You clean your toilet bowl almost every day, but it somehow gets dirty in no time? This is a quite common though very frustrating scenario and the reason might be one of these: Chlorine in hard water. This combination causes the iron and magnesium to precipitate out and thus muck up the toilet.
When cleaning a toilet bowl, WD-40 works by softening the rust and lime deposits, so they can be easily wiped away. You don't need to use much of it. Simply spray on the affected area, wait a minute or two and brush it away with a regular toilet brush.
Toilet seat stains are common and can be caused by product build-up, urine, fake tan, dead skin, mineral deposits and certain cleaning products. The stains can range from orange to yellow to brown or green, depending on the cause of the stain.
To prevent calcium carbonate from piling up into your cistern, pour a single cup of white vinegar into it. The mixture should be three parts white vinegar to one water. After you pour it into the cistern, mix it slowly and carefully until it's evenly distributed.
The carbonic acid that is in coke is what helps to clean toilet stains. Picture the acidity slowly working its way through the stains, melting them away. It can take a while depending on how stubborn the stain is which is why it's vital to have a suitable cleaning method depending on how bad the toilet condition is.
Vinegar will not damage your toilet in any way if it's left in your toilet overnight. In some cases, leaving the vinegar in your toilet overnight is recommended to get the best cleaning results. No matter what material your toilet is made from, the vinegar will not damage your toilet.
Pour one cup of baking soda into the clogged toilet, and then chase it with the hot water/vinegar mixture. Leave the volcano mix to do its job, checking in about 30 minutes. In most cases the clog will have come apart, and a simple flush with send it all down the drain. Plus your toilet bowl will be cleaner!
Let the vinegar and soda solution sit for up to 30 minutes. If there are any stains above the water line, it would be helpful to go over them with your toilet brush one or two more times. One final scrub before you flush should remove any still stuck stains. Flush to rinse.
To remove tough stains, add the baking soda and vinegar mix to your toilet and then allow the solution to sit in the bowl for up to 30 minutes. During that time, the chemical reaction between the sodium bicarbonate and vinegar will work to eat away at those stubborn hard water stains.
Watch the level of fizz because this is definitely a situation where the science fair volcano would not be desired. Let the mix sit for anywhere between two hours to overnight. If the water levels have drained try flushing, and if the water levels have not moved you can try plunging gently plunging.
These are the main reasons why there might be a black ring around the toilet: Mineral deposits on your water supply. Mildew and mold spores. Bacteria buildup such as Serratia marcescens.