The best way to shorten lights wired in series is to remove an entire series section of lights by cutting lights apart where there are only has two wires, with the lights unplugged. Then, simply cap each of the two cut wires with a wire connector.
LED light strips are favored for their versatility and flexibility — particularly since they can be cut to fit different areas of your home. Whether you want to add extra illumination to your kitchen counters or a backlight for your TV, LED strips can be trimmed to fit your needs and space.
Yes! You can cut any of our battery-powered, USB, or solar-powered fairy lights to whatever length you desire.
If half a strand is working and the other half is not, you probably have a loose or broken bulb. Start with the first unlit bulb and work your way down, wiggling them to check for looseness. If it flickers, that's your cue to replace it.
LED strip lights are designed to make cutting easy, so all you will need is a pair of scissors. Either follow the cutting line (that sometimes also has a scissor icon on it) or cut between the pair of copper dots that show up at the end of each LED unit.
At lower currents, diodes fail with a short due to overheating of the semiconductor. At higher currents, especially with LEDs which use a bond wire for the top connection, they fail open. At lower currents, diodes fail with a short due to overheating of the semiconductor.
Yes, you can remove and restick LED strip lights from one place to another. They are not like the usual lights that need permanent fixtures. You can reuse strip lights when you move from old house to new house.
An LED strip light is typically half an inch (10-12 mm) in width, and up to 16 feet (5 meters) or more in length. They can be cut to specific lengths using just a pair of scissors along the cutlines, located every 1-2 inches.
You cannot cut just anywhere on your LED strip. Instead, you must follow the guides located on the strips that will tell you where you can cut them. The LED strips should have copper dots or ovals, typically located every three LEDs. These markers indicate cut points where you can make a cut in the strip.
The other, negative side of the LED is called the "cathode." Current flows from the anode to the cathode and never the opposite direction. A reversed LED can keep an entire circuit from operating properly by blocking current flow. So don't freak out if adding an LED breaks your circuit. Try flipping it around.
Many of the current LED lights and bulbs actually have a translucent or clear outer plastic covering (usually to mimic a traditional bulb shape) with the LED emitter far inside; those plastic coverings are safe to touch.
LEDs, being diodes, will only allow current to flow in one direction. And when there's no current-flow, there's no light. Luckily, this also means that you can't break an LED by plugging it in backwards. Rather, it just won't work.
If you have your light strip, take a look at the copper sections. If they are marked with a small “scissor” icon, you can cut along the markings. If you don't see a scissor icon along the copper markings or, this most likely means you cannot cut your LED light strips.
Once you've cut your strip light, you can reconnect them by using either a connector or by soldering. If your LED strip lights won't work after you've cut them, the most likely reasons could be that you either cut them in the wrong place or your lights weren't designed to be cut.
Three wires allow half of the string to remain lit if the other half fails. Instead of wiring the string in parallel.
Fairy Lights vs String Lights Explained
Because fairy lights typically come in strands, they are also called string lights. But string lights encompass a wide variety of designs, so the term isn't quite accurate when referring to fairy lights.